MachineBuilding
px

Point of load converters have maximum output of 80W

TDK-Lambdavisit website

 

Lambda is adding to its range of point of load converters with the launch of the iAD series of non-isolated, single inline package, through-hole mounting devices. Featuring a DOSA-compatible pin out, the iAD series addresses a broad range of applications, from telecommunications through to industrial equipment.

With its wide input range from 6-14V DC, the iAD12016A008V is particularly well suited for powering today's diverse range of loads in a variety of architectures including distributed power, such as regulated 9V DC or 12V DC bus rails or non-regulated 4:1 and 5:1 bus converter systems. Furthermore, its broad output adjustment range from 0.8-5.5V DC, its maximum output power of 80W and its ability to start into a pre-biased load make it especially useful in ASIC/FPGA and other applications where multiple voltages can be present.

Special attention has been paid to the electrical design to gain a high power conversion efficiency of up to 94 per cent. Together with careful component layout, this allows the iAD series to provide better thermal performance than many similar devices. The designer can then benefit from higher output power for a given thermal environment, or lower thermal stress for the same output power. Using proven circuitry, the low component count provides greater reliability and a more cost-effective solution than other modules on the market.

The iAD POL converter's standard features include fixed-frequency operation, remote sense, remote on/off, flexible output voltage sequencing, auto-recovery of input under voltage and output over current protection circuitry.

Negative polarity on/off, no-output voltage sequencing, an industry-standard narrow 9.6-14V DC input voltage range as well as short 0.13inch (3.3mm) pins are offered as options.

Safety approvals include UL60950 (USA and Canada), VDE 0805, CB scheme (IEC 950), and CE Mark (EN 60950). All models carry a three-year limited warranty.

 
© Copyright 2006-14 Damte Ltd.