8mm inductive LVDT probes suits high-volume OEM environments

LVDT gauging sensors are primarily used for measuring workpiece geometry such as length, height, width, diameter, thickness and depth. Pneumatic probes, for example, are suitable for use in automatic gauging applications or for accessing details that would be difficult or impossible to reach using conventional spring-loaded (spring push) probes. Some materials such as glass or plastic, for example, require very low tip forces to prevent deformation of the component being measured, as well as contact tip materials that do not leave marks on the component. Therefore, the DTA-XG8 is activated via a feather touch spring.

With a stainless steel housing with a diameter of just 8mm, the sensor can be installed in areas where space is tight or restricted. The standard sensor is protected to IP54 (without bellows) but to prevent the ingress of dust and water between the sensor tip and housing, an IP65 version with bellows seal is available.

The product family includes measuring ranges of +/-1mm, +/-3mm, +/-5mm and +/-10mm. Linearity is 0.3 per cent (FSO) of the measurement range. Resolution is dependent upon the drive circuit. The MSC710 series, for example, has a resolution of 0.00018 per cent (FSO). Operating temperature range is from -20degC to +80degC without bellows and 0 to +80degC with bellows. All sensors are supplied with a 3m axial cable. Both the sensor and the electronics can be customised for high-volume projects.

Follow the link for more information about Micro-Epsilon's induSENSOR DTA-XG8 sensors.