Autodesk reports that more businesses across the European marine technology, wave and tidal power sectors are implementing its software following the launch of its Clean Tech Partner Program.
16th June 2011
O-Flexx Technologies is using Autodesk's 3D design and engineering software to develop innovative ways of powering off-grid sensors and converting waste heat into electricity.
Abssac has supplied a custom split nut and power lead screw for positioning an automated glue dispensing head.
14th June 2011
Igus has produced a short movie that shows some of the applications for polymer plain bearings on bicycles.
9th June 2011
HBM's eDAQ data acquisition system has been used in a Partial Air Cushion Supported CATamaran demonstrator landing craft developed by QinetiQ.
1st June 2011
Customised Micro-Epsilon optoNCDT 1700 laser displacement sensors are being in a special-purpose system for measuring the height of concrete blocks during the production process.
24th May 2011
HMK has developed a flying shear crosscut and sheet stacking system for CM Machinery using Siemens servo motors and controls.
22nd May 2011
Eriks Integrated Solutions has been awarded a five-year, single-supplier MRO contract by Brand-Rex.
15th May 2011
Eriks Integrated Solutions has won a major multi-million-pound contract from British Gypsum.
Igus has produced a short and humorous film that demonstrates the conditions under which iglidur bearings are operating on three-wheeled rickshaws.
13th May 2011
